Hot roll, it is based on the slab as raw material, after heat made strip roughing and finishing mill group. From finishing the last hot steel strip mill out through laminar flow cooling to the set temperature, Angle of the winder coil, steel coil after cooling.

SPECIFICATIONS: ASTM A516 GRADE 70 A20 ASME SA516 GRADE 70 SA20
Carbon A516 (ASTM A516, ASME SA 516) is a pressure vessel quality (PVQ) steel plate conforming to ASTM A516-70. When normalized above 1-1/2¿ thick, it has improved impact toughness. A516 plate is one of the strongest and most versatile PVQ plates commercially available.

AISI 1045 steel is a high-strength high-quality medium carbon steel. Also known as JIS S45C and din C45 steel. Because of its poor hardenability, it is usually used in normalized state. Quenching and tempering treatment is needed to obtain higher mechanical properties. Used for manufacturing mechanical parts with high strength requirements. Such as gears, shafts, piston pins, etc.
It has good weldability and machinability. After normalizing and hot rolling, high strength and impact properties will be obtained. The hardenability is low, and the critical hardenability diameter in water is 12-17mm. And it tends to crack during water quenching. Hydrogen welding and argon arc welding are good for it, but gas welding is not. Preheating is required before welding, and stress relief annealing shall be carried out after welding.

S355JR steel plate is widely used in mining machinery manufacturing, shipbuilding, hoisting machinery equipment, hydraulic equipment, metallurgical machinery manufacturing, engineering machinery manufacturing, water conservancy and hydropower, wind power projects, etc. it can also be used to cut bearing seats, large tailor welded flanges, large structural parts, etc.
Carbon steel is the basic material with the earliest use and the largest consumption in modern industry. While striving to increase the output of low-alloy high-strength steel and alloy steel, all industrial countries in the world also pay great attention to improving the quality of carbon steel and expanding the variety and scope of use.

EN 34CrNiMo6 Steel is an important alloy engineering steel grade as per BS EN 10083-3:2006. 34CrNim06 steel has high strength, high toughness and good hardenability. EN / DIN 34CrNiMo6 alloy steel has the stability of resistance to overheating, but the white sensitivity of 34CrNiM06 is high.

Hardox wear plate is the world's leading abrasion-resistant (AR) steel. Hardox is hard through and through, from the surface deep down to its core, giving you extended service life and high productivity in the most challenging environments.

15Mo3 steel plate/sheet, DIN 17155 15Mo3 steel plate/sheet, under DIN 17155 standard, we can regard 15Mo3 steel plate/sheet for boiler steels.DIN standard 15Mo3 pressure vessel steel has now been superseded with the Euro Norm specification EN 10028.

WearTuf 500 Abrasion Resistant Steel Plate combines wear resistant properties with excellent weldability and bending performance. Due to the high impact toughness, WearTuf 500 offers very good crack integrity.

ASTM A514 steel plate is a steel plate material known for its high yield strength, weldability, and toughness, even at low temperatures. ASTM A514 is a low carbon quenched and tempered alloy steel that is a low-cost, high performing material for structural use and high wear machine applications. A514 steel plate meets the ASTM International standard A514. This steel plate has a yield strength of 100,000 psi (100 ksi or approximately 700 MPa).